Removing The System Memory (Ram) - Clevo NL51CU Service Manual

Removing the System Memory (RAM)

The computer has two memory sockets for 260 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
DDR4 2400MHz. The main memory can be expanded up to 32GB. The total memory size is automatically detected by
the POST routine once you turn on your computer.
Memory Upgrade Process
1. Turn off the computer, turn it over to remove the battery
2. The RAM modules will be visible at point
3. Gently pull the two release latches (
arrows (Figure 5b).
4. The RAM module will pop-up
4
a.
1

Single Memory Module Installation
If your computer has a single memory mod-
ule, then insert the module into the Channel
0 (JDIMM1 / RAM1) socket.
(page 2 - 5).
on the mainboard (Figure 5b
1
& ) on the sides of the memory socket in the direction indicated by the
2 3
( )
Figure 5c , and you can then remove it
b.
2
3
)
.
.
c.
2
4
3
Removing the System Memory (RAM) 2 - 9
Disassembly
Figure 5
RAM Module
Removal
a. The RAM modules will
be visible at point 1
on the mainboard.
b. Pull the release lat-
ches.
c. Remove the module.

Contact Warning
Be careful not to touch
the metal pins on the
module's connecting
edge. Even the cleanest
hands have oils which
can attract particles, and
degrade the module's
performance.

4. RAM Module