Table of Contents
Advertisement
(2)
Set the registration.
(3)
Press the DiSK button.
The DISK button lamp lights and the multifunction
display indicates the following. The first song is se¬
lected at this time.
SR70
Notes:
• Recording and replaying of a song cannot be done
with a disk other than a sequencer disk.
• If "REG" or "RHY" is displayed on the multifunction
display, the inserted disk is not a sequencer disk. Ei¬
ther insert a sequencer disk, or reformat the inserted
disk as a sequencer disk. (Refer to page 63 for the
formatting procedure.)
(4) Select the song number to be recorded with the plus
{+)
and minus ( -) buttons.
The song number is displayed on the multifunction
display.
The track button lamp on which the selected song is
recorded lights.
I—Song number
JlbN
c:
c: n
-J L-
u
Notes:
• Press the track button whose lamp is lit; turning off the
lamp will result in the inability to record and replay
songs in that track.
• Track buttons will not light when pressed if nothing
has been recorded on that track.
(5) Press the RECORD button.
The amount of remaining space on the floppy disk is
displayed in kilobytes on the multifunction display.
^ PLAY
^ STOP
Record
cdI 1
1 CP
Note:
Each floppy disk has a maximum capacity of 620 kilo¬
bytes.
1
3
DISK_
-
h
n n
LJ u
The lamps of all tracks that have not been recorded start
flashing.
The disk lamp stays lit
continuously, but the
other lamps flash.
Note:
If the write protect is on, a long beep is sounded, and
"ERR" is displayed on the multifunction display. The
DISK button lamp turns off and the disk mode is can¬
celed.
47
Advertisement
Table of Contents
