Filter Valve And Discard Valve Switches; Temperature Probe - Vulcan-Hart ERO15 Service Manual

ER SERIES ELECTRIC FRYERS - REMOVAL AND REPLACEMENT OF PARTS
3. Lift the cooking control with mounting panel
attached, off the front control panel.
4. Reverse procedure to install.
5. Re-connect power and turn power switch on.
6. Program the cooking control for the control
type as outlined under SOLID STATE
CONTROL or COMPUTER CONTROL in
SERVICE PROCEDURES AND
ADJUSTMENTS.
NOTE: If installing a replacement cooking control,
program the control with the customers settings and
products.
7. Check for proper operation.
FILTER VALVE AND DISCARD
VALVE SWITCHES
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT
/ TAGOUT PROCEDURES. THERE
MAY BE MULTIPLE CIRCUITS. BE
SURE ALL CIRCUITS ARE
DISCONNECTED.
1. Open the door to the fryer section being
serviced.
2. Disconnect lead wire connector (2 pin) to the
switch.
3. Remove switch mounting screws.
F35613 (September 2003)
4. Remove switch cover and disconnect lead
wires from switch.
5. Reverse procedure to install and check for
proper operation.
NOTE: Switches are not adjustable.

TEMPERATURE PROBE

CAUTION: Do not sharply bend and kink the
temperature probe or damage may occur.
1. Raise heating elements.
2. Remove clamps from temperature probe.
3. Remove element head cover as outlined under
COVERS AND PANELS.
4. Disconnect temperature probe lead wires.
Page 10 of 48
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT
/ TAGOUT PROCEDURES. THERE
MAY BE MULTIPLE CIRCUITS. BE
SURE ALL CIRCUITS ARE
DISCONNECTED.