Tilt Switch - Vulcan-Hart ERO15 Service Manual

ER SERIES ELECTRIC FRYERS - REMOVAL AND REPLACEMENT OF PARTS
4. Remove lift assist springs from the eye bolt
hooks.
5. Remove lift assist springs from the hangers.
6. To install springs:
A. Attach spring hook to hanger thru rear
door opening.
B. Attach spring hook to eye bolt and tighten
eye bolt mounting nut.
C. Remove 2x4 lumber and lower heating
elements.
7. Adjust spring tension as outlined under LIFT
ASSIST SPRING ADJUSTMENT in SERVICE
PROCEDURES AND ADJUSTMENTS.
F35613 (September 2003)
1. Remove element head cover as outlined under
COVERS AND PANELS.
2. Lower heating elements.
3. Disconnect lead wires from tilt switch.
4. Remove tilt switch from element head.
REAR VIEW SHOWN, ELEMENTS LOWERED
FRONT VIEW SHOWN, ELEMENTS RAISED
5. Reverse procedure to install and check for
proper operation.
NOTE: The tilt switch and magnet are mounted in
fixed locations and are not adjustable.
Page 14 of 48

TILT SWITCH

WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT
/ TAGOUT PROCEDURES. THERE
MAY BE MULTIPLE CIRCUITS. BE
SURE ALL CIRCUITS ARE
DISCONNECTED.