Table of Contents
Advertisement
VK / TR SERIES GAS FRYERS
Open the filtering drawer approximately 1" to allow any oil in the return line to run back into the filter
pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter
components.
1. Pull the filter drawer out and remove the crumb basket and empty any debris into the trash.
2. Remove the filter screen assembly. Scrape debris from the filter screen. Then remove the
insert by unlatching the latch. Clean all parts thoroughly as mentioned in the Assembly
section on page 19.
3. Scrape debris from the bottom of the filter pan and discard in the trash. Clean all parts
thoroughly as mentioned in the Assembly section on page 19. Clean all parts thoroughly as
mentioned in the Assembly section on page 19.
4. Reassemble all filter components after being dried thoroughly as in the Assembly section on
page 19.
1. Follow filtering instructions 1-3, however do not put oil treatment media into the fryer. Drain
the fryer oil into the filter pan.
2. Attach the quick disconnect hose to the discard male quick disconnect fitting,
3. To discard the oil, place the nozzle end of the discard hose into a
container that is large enough to retain the discarded shortening.
Press the filter switch behind the door to the "USE HOSE TO
DISCARD ONLY" position. This will allow all of the oil to be pumped
through the hose only.
4. For flushing/rinsing the tank with filtered oil to remove the particulates
that have accumulated, press the filter switch behind the door
to the "USE HOSE TO RINSE AND FILL" position. This will
allow the oil to pass through the hose and come in from behind
the tank at the same time.
5. With the power switch still ON; press the discard/flush switch on. Press and hold the filter
button for at least 3 seconds and the Motor/Pump will begin to operate. NOTE: Oil will exit
immediately out of the nozzle end of the hose.
6. Once the oil has been discarded completely and the filter pan is empty, press the filter button
to turn off the Motor/ Pump. Then press the discard/flush switch off.
VULCAN-HART
REMOVING EXCESS DEBRIS FROM THE SCREEN FILTER:
FLUSH/RINSE AND DISCARD OIL:
FILTERING TIP:
-26-
F-32971 Rev. M (June 2013)
Advertisement
Table of Contents
