Electrical Connections; Electrical Data - Vulcan-Hart GCO2C Installation And Operation Manual

LEVELING
Once the oven is in its permanent position, place a carpenter's level on the oven rack. If the oven is installed
on legs, turn the adjustable feet in or out to level oven front-to-back and side-to-side. If the oven is installed
on casters, loosen set screws and turn casters in or out to level oven front-to-back and side-to-side.
Retighten set screws after leveling.

ELECTRICAL CONNECTIONS

Electrical and grounding connections must comply with the applicable portions
of the National Electrical Code and/or other local electrical codes.
Appliances equipped with a flexible electric supply cord are provided with a
three-prong grounding plug. It is imperative that this plug be connected into a properly
grounded three-prong receptacle. If the receptacle is not the proper grounding type, contact an
electrician. Do not remove the grounding prong from this plug.
The 120 volt models are equipped with a cord and plug.
Refer to electrical wiring diagram located inside the right side panel; remove control panel for access.
Do not turn the power supply on until after the gas connections have been made and checked for leaks.
Model Volts
120
GCO2D 200-240
208-240
120
GCO2C
200-240

ELECTRICAL DATA

Hertz Phase
60 1
50 1
60 1
60 1
50/60 1
– 6 –
Minimum Circuit Ampacity
Maximum Protective Device
AMPS
15
15
15
15
15