Assembling The Stand To The Oven; Electrical Connections - Vulcan-Hart C4ED Installation And Operation Manual

ASSEMBLING THE STAND TO THE OVEN

Attach each of the four leg assemblies to the bottom of the
oven with the 24 bolts and lockwashers (six per leg).
Carefully raise the oven to the normal position.
Attach the undershelf to the legs with eight bolts and
lockwashers (two per leg).
Install the rack guides into the shelf at the desired locations
(for pan or flat rack), then attach the rack supports to the
top end of the rack guides. Attach rack supports to the leg
assembly by removing one middle bolt and reattaching the
back through the end holes in the rack support (Fig. 2).

ELECTRICAL CONNECTIONS

WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE
APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE ANSI/NFPA70 (LATEST EDITION)
AND/OR OTHER LOCAL ELECTRICAL CODES.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT
SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT.
Remove the wiring compartment cover on the front of the oven. Remove the appropriate knockout on
the bottom of the oven and attach the power supply conduit to the bottom of the oven.
Comply with the appropriate wiring diagram (located inside the right side panel) when making
connections to the electrical supply lines.
Replace the wiring compartment cover and right side panel. Turn on the power supply.
TOTAL 3-PHASE LOADING 3-PHASE LOADING
KW KW PER PHASE
L1-L2 L2-L3 L1-L3 L1-L2 L2-L3 L1-L3
Single Oven 12.5
Stacked Oven 25
ELECTRICAL DATA
208-240 V 480 V
KW PER PHASE
4 4 4.5 4 4
8 8 9 8 8
NOMINAL AMPERES PER LINE WIRE
208 V
L1 L2 L3 L1
4.5 35 33 35 33
9 70 66 70 66
– 5 –
BACK
FRONT
Fig. 2
3-PHASE
240 V 480 V
L2 L3 L1 L2 L3
29 33 14.4 15.3 15.3
58 66 28.8 30.6 30.6
PL-53274
1-PHASE
208 V 240 V 480 V
60 52 26
120 104 52