Table of Contents
Advertisement
CASTERS
If the oven is to be installed on casters, assemble the
casters to the legs provided. Then attach the caster-leg
units to the oven at each corner using the 24 b olts and
lockwashers. place the locking casters on the front legs
and nonlocking casters on the rear legs. Units on casters
BACK
should be tethered to the building using the strain relief
bracket shown in Figure 2.
Fig. 2
ASSEMBLING THE STAND TO THE OVEN
Attach each of the four leg assemblies to the bottom of the
oven with the 24 bolts and lockwashers (six per leg).
Carefully raise the oven to the normal position.
Attach the undershelf to the legs with eight bolts and
lockwashers (two per leg).
Install the rack guides into the shelf at the desired locations
(for pan or
t rack), then attach the rack supports to the
top end of the rack guides. Attach rack supports to the leg
FRONT
assembly by removing one middle bolt and reattaching the
back through the end holes in the rack support (Fig. 2).
PL-53274
Fig. 3
ELECTRICAL CONNECTIONS
Remove the wiring compartment cover on the front of the oven. Remove the appropriate knockout on
the bottom of the oven and attach the power supply conduit to the bottom of the oven.
Comply with the appropriate wiring diagram (located inside the right side panel) when making
connections to the electrical supply lines. Use exible conduit only.
Replace the wiring compartment cover and right side panel. Turn on the power supply.
– 5 –
Advertisement
Table of Contents
