Removals and Replacements
1065 DRB Power Supply
Removal
• Unplug the power cord from the electrical outlet.
• Remove left cover (1
005).
• Remove right cover (1006)
.
• Unplug the DRB hand-held unit from its power supply.
• Remove the bezel from the front of DRB power supply (1 035).
• Unplug the DRB power supply from the power distribution contro!
box (see page 83 for the location)
.
• Remove any cable ties that may be restraining the cable.
• Remove the plate
D
from the center frame divider.
• Unplug the DRB connector from P5 from the power distribution
board on the left side of the system
.
See page 82 for the
location
.
Thread this cable through to the right side of the
system
.
• Remove the power supply by pressing the locking pin
fJ
on the
side of the cage and pushing the power supply forward at the
same time.
66
Service Bay System
•