10.0 Menu Features And Programming Instructions; Programming The Primary Filtration - Sundance Spas Export 680 Series Owner's Manual

680 Export Series

10.0 Menu Features and Programming Instructions

Your hot tub is equipped with menus that allow you to program additional
features. By continually pressing the Menu (
through the menus as follows (Figure 10.0a):
Current temperature (Main Menu)
Primary Filtration (page 28)
Heat (page 29)
Filter Change (page 30)
UV (page 30)
H2O (page 31)
Time (page 31)
Date (page 32)
Temp (page 32)
Language (page 32)
Lock (page 33)
WiFi (not applicable)
Elog (End of Menu)
10.1

Programming the Primary Filtration

During the primary filtration cycle, the pump 1 low speed and
CLEARRAY are activated. The hot tub is programmed to cycle 4 times
(every 6 hours) throughout the day, each cycle last 2 hours, and a default
start time of 12:00 AM, but this can be changed.
A. Primary Filtration Menu
To change the programmed Primary Filtration Cycle:
Note: If no button is pressed within 5 seconds of each
selection the screen will revert back to the Main Menu and the current
settings will remain active.
1. Press until you get to the "PF" Menu. The display will scroll
"PRIMARY FILTER." After the second scroll, if no action is taken, the
system will revert back to the Main Menu.
2. Press or
system for changes.
3. Press or
switch from "AM" to "PM" you must round a 12-hour period.
Page 28
to display the current start time and prepare the
to adjust the start time, in 1-hour increments. To
) button you will cycle
Figure 10.0a