Programming Instructions; Programming Filter/Circulation Pump (Standard Mode); Programmable Heat Cycles (Economy Mode Only) - Sundance Spas Cameo Owner's Manual

880 SERIES

12.0 Programming Instructions

12.1 Programming Filter/Circulation Pump (Standard Mode)

The Sentry control system allows you to easily adjust two separate
aspects of filter/circulation pump operation:
• The time of day (start time) the filter/circulation pump turns on.
• The length of time (duration) the filter/circulation pump operates.
The factory default start time is 12:00AM (midnight). The default duration
is 24 hours. To make adjustments, press the (CYCLE)
once to enter the filter/circulation pump programming mode. The LCD
screen will display "Circ" At this time the system is ready to accept your
changes:
• Press the (SELECT)
start time appears on the LCD display.
• Press (UP)
30-minute increments.
• Press the (SELECT)
• Press (UP)
time in 1 hour increments.
• Press (DISPLAY)
water temperature display.
Note: If no button is pressed within 30 seconds, all changes are
recorded and the screen automatically returns to the standard water
temperature display.
Note: When the standard mode is selected (Section 11.3), the filter/
circulation pump automatically turns on for a heat call regardless of the
pump's programmed start time and duration.

12.2 Programmable Heat Cycles (Economy Mode Only)

Your hot tub comes with four 30-minute filter cycles which activate the
filter/circulation pump while in economy mode. These cycles are factory
programmed to start at 6:00 AM, 12:00 (noon), 6:00 PM, and 12:00
(midnight). The control system allows you to easily adjust two separate
aspects of each cycle:
• The time of day at which it begins;
• The duration of the cycle.
Note: When "Economy" mode is selected (Section 11.3), the heater
activates only during a programmed filter cycle period. When a Summer
Logic condition is active (page 39), the filter/circulation pump will turn on
for all programmed filter cycles.
Page 38
button once. The previously programmed
or (DOWN)
buttons to program duration.
or (DOWN)
button to save changes and recall the main
buttons to adjust the start time in
buttons to program the duration
button