Menu Features And Programming Instructions; Primary Filtration Menu - Sundance Spas Hamilton Owner's Manual

10.0 Menu Features and Programming Instructions

Your hot tub is equipped with menus that allow you to program additional
features. By continually pressing the Menu (
through the menus as follows (Figure 10.0a):
Current temperature (Main Menu)
Primary Filtration (page 31)
Secondary Filtration (page 32)
Heat (page 33)
Filter Change (page 34)
UV (page 34)
H2O (page 35)
Time (page 35)
Date (page 36)
Temp (page 36)
Language (page 36)
Lock (page 37)
WiFi (50Hz models only - optional)
S\N (page 25)
10.1

Primary Filtration Menu

During the primary filtration cycle, the circulation pump and CLEARRAY
are activated. The hot tub is programmed with a default setting starting
at 12:00 AM and lasting for 8 hours, but this can be changed. This cycle
allows the circulation pump to run for a preset amount of time per day, in
addition to the normal operation.
Note: Any time the circulation pump runs outside of a program cycle,
e.g. for heating, that run time will be deducted from the next primary
filter cycle. For example, the primary filter cycle is set to 8 hours every
24 hours but the circulation pump comes on for 2 hours to heat the
water after the cycle has finished. The next primary filter cycle will only
be for 6 hours not 8 hours.
780 Series
) button you will cycle
Figure 10.0a
Page 31