Programming Instructions; Programming Filter/Circulation Pump Run Time; Programmable Filter Cycles - Sundance Spas Altamar Owner's Manual

12.0 Programming Instructions

12.1 Programming Filter/Circulation Pump Run Time

The Sentry control system allows you to easily adjust two separate as-
pects of filter/circulation pump operation:
1. The time of day (start time) the filter/circulation pump turns on.
2. The length of time (duration) the filter/circulation pump operates.
The factory default start time is 12:00am (midnight). The default
duration is 24-hours. To make adjustments, press the (CYCLE)
button five times to enter the filter/circulation pump programming mode.
The LCD screen will display "Circ" At this time the system is ready to ac-
cept your changes:
• Press the (SELECT)
start time appears on the LCD display.
• Press UP
minute increments.
• Press the (SELECT)
• Press UP
hour increments.
• Press (DISPLAY)
water temperature display. Note: If no button is pressed within 30
seconds, all changes are recorded and the screen automatically
returns to the standard water temperature display.
Note: When the standard mode is selected (sec. 11.3), the filter/
circulation pump automatically turns on for a heat call regardless of the
pump's programmed start time and duration.

12.2 Programmable Filter Cycles

Your hot tub comes with four 30-minute filter cycles which activate the
filter/circulation pump. These cycles are factory programmed to start
at 6:00 am, 12:00 (noon), 6:00 pm, and 12:00 (midnight). The control
system allows you to easily adjust two separate aspects of each cycle:
1) the time of day at which it begins; 2) the duration of the cycle.
Note: When "Standard" mode is selected (sec. 11.3) and the filter/
circulation pump is set to the factory default duration of 24-hours
(sec. 12.1), each cycle is displayed on the main control panel, when
running, but no apparent change of operation will occur. However,
button once. The previously programmed
or DOWN buttons to adjust the start time in 30-
buttons to program duration.
or DOWN buttons to program the duration time in 1
button to save changes and recall the main
Page 49