Table of Contents
Advertisement
680 Export Series
13.11
Panel Displays OH
WARNING:
!
CAUSING SEVERE INJURY, BURNS, OR WELTS.
Water temperature is above acceptable limits. DO NOT
ENTER SPA! Water temperature has reached (112°F). The
Jets Pump 1 has activated to circulate water through heater.
Contact your authorized Sundance Spas dealer or qualified service
technician. The display will alternate between "*OH*" and the current
water temperature.
Note: As a safety measure, the red lights of the spa will flash on and off
as an indication that the spa is an overheat condition.
To correct condition:
•
Remove the spa's cover and allow your spa to cool down.
•
Program the heater settings for Economy Mode (page 31).
•
If the condition persists, contact your authorized Sundance Spas
dealer.
13.12
Panel Displays (-- -- -- --)
WARNING:
!
CAUSING SEVERE INJURY, BURNS, OR WELTS.
Water temperature is above acceptable limits. DO NOT
ENTER SPA! The safety "Watchdog" software has been
triggered and the spa is deactivated. A problem has been
detected which could cause damage to the spa or its components. The
display will alternate between "-- -- -- --" and the scrolling message
"WATCHDOG CALL FOR SERVICE" as long as the error exists.
Contact your authorized Sundance Spas dealer or qualified service
technician.
Note: As a safety measure, the red lights of the spa will flash on and off
as an indication that the spa is in watchdog condition.
14.0 Troubleshooting Procedures
In the event your spa is not working the way it should, please first review
all the installation and operating instructions in this manual and check the
message on the panel display. If you are still not satisfied it is working
properly, please follow the appropriate troubleshooting instructions below.
Note: If any of the supply cords to the accessories are damaged, they
must be replaced by authorized service personnel.
Page 46
RISK OF HYPERTHERMIA (OVER-HEATING)
RISK OF HYPERTHERMIA (OVER-HEATING)
Advertisement
Table of Contents
