Selecting Desired Massage Action; Air Controls; Optional Bluewave® Spa Stereo System; Blow-Out Cycle - Sundance Spas Export 680 Series Owner's Manual

9.5

Selecting Desired Massage Action

All models (except Edison, Peyton, Prado, Prado 5 and
Tacoma) incorporate a massage selector valve or Diverter
Jet that allows you to customize the massage and
performance by diverting water between various jet systems
within the spa. Simply turn valve to positions A, B or C to
divert water pressure to various jet groups.
Note: The valve is intended to operate in positions A
(Combo), B, or C for optimum performance. It is considered
normal for sound levels within the valve to increase between
these positions due to the large amounts of water flowing
through it. For optimum filtration benefits, always leave this
valve in position A when the spa is covered and select positions
B or C for maximum jet performance during spa use.
9.6

Air Controls

Certain jet systems have their own air control. Each
control introduces air into the water lines that supply that
specific jet group. Simply turn the air control selection
to open or close. To minimize heat loss, all air controls
should be closed when the spa is not in use.
Note: To minimize heat loss, close all air controls when spa is
not in use. Certain jets may not draw air while the jets pump
is running in low speed; this is considered normal.
9.7 Optional BLUEWAVE® Spa Stereo System
Models equipped with the optional audio system offer
enhanced spa enjoyment. These models include a high-
quality AUX/Bluetooth® stereo receiver with four high-quality
marine speakers for unsurpassed sound quality and long-life.
Note: All operations for the BLUEWAVE system are
controlled via a connected Bluetooth or Auxiliary device.
9.8

Blow-Out Cycle

This cycle will purge the air from the plumbing lines normally caused by
draining and filling the spa. The Jets Pump 1 (low speed) will turn on for
1 minute and then shut off. Then Jets Pump 2 (if equipped) will turn on
and run for 1 minute then shut off. This cycle will only occur at start up.
Note: Turning off the corresponding jets pump that is running can
deactivate the feature.
9.9

Cleanup Cycle

The cleanup cycle occurs once per day at 12:00 PM (noon) for 2
minutes. This is not user programmable. The Jets Pump 1 (low speed)
will turn on for one minute and then shut off. Then Jets Pump 2 (if
equipped) will turn on and run for 1 minute then shut off.
Note: Turning off the corresponding jets pump that is running can
deactivate the feature.
680 Export Series
C
B
A
McKinley and
Ramona models
Denali model
Edison, McKinley,
Peyton, Prado and
Ramona models
Denali model
Page 27