Table of Contents
Advertisement
14. Reconnect the UV bulb socket (6) to the power cord socket (4) make
sure you use the latex glove provided when handling the UV bulb.
WARNING:
YOUR BARE HAND. Oil on your skin will cause hot spot on
!
the UV bulb and shorten the life of your UV bulb. Use the
provided latex glove to handle the UV bulb.
15. Slide the new UV bulb (7) back inside the quartz tube.
16. Reinstall the black bulb boot (5) back over the quartz seal
compression nut (9).
17. Reinstall the enclosure cover (2) and secure with the screws.
18. Properly dispose of the old UV bulb.
WARNING:
!
which contains mercury. Dispose of the bulb in accordance
with disposal laws. See www.lamprecycle.org.
19. Once power is activated you can check the ballast,
Figure 7, to see if the CLEARRAY System is
functioning. The power on (red) light indicates that the
CLEARRAY System is being provided power and
should always be on. The lamp on (green) light
indicates that UV bulb is activated.
DO NOT TOUCH THE NEW UV BULB WITH
This CLEARRAY System includes a UV bulb,
680 Export Series
DANGER!
TURN POWER
OFF! DO NOT
LOOK AT LIT BULB.
SEVERE EYE
DAMAGE OR BLINDNESS
CAN OCCUR!
Power
Lamp
on
on
FIGURE 7
Page 43
Advertisement
Table of Contents
