Advertisement
6-2. Measurement in Ambient Light Mode &%
Select Ambient Light Mode when taking measurements of continuous light
source such as sunlight, tungsten lamps, or fluorescent lights.
QF
1) Depending on what type of camera is being used,
a 5
select "Digital" or "Film" mode. (Press the MENU
mB
RA m
a
button [Il and select the [T:
LLF1] menu)
Mi
(See P10)
=
2) While pressing the MODE button El, turn the
(eee) orl
eS
Jog wheel IE, to select the & Ambient Light
2
Q
f ur
Mode. (See P11)
2
NR
3) Select the Display Mode.
=
5
Ò
z
Press the DISPLAY Selecting Button E, turn the Jog & || / Q
)
=
wheel to select the desired Display Mode. (See P12)
EI
\ o` G
A
4) Set the selected color temperature. (See P14)
[5
S
MODE
MENU
SET k a
[Reference]
Button El Button Il Button om
©:
only using the selected color temperature
|
display mode, you can omit this step.
5) If you need to compensate the indicated value on LCD screen, you can recall
saved preset White Balance/Color Compensation and apply those settings to
the indicated values.(While pressing the PRESET button E turn the Jog
wheel E to select from the stored Preset numbers 1 through 19.) (See P16)
[Reference]
@Preset white balance/color compensation values must be saved in advance. (See P36)
6) Press the Measuring/OK button EA. Measurement will be taken and the
measured/indicated values will be displayed.
While the button is held, the meter measures continuously. When the button
is released, the measurements will stop and the measured/indicated value at
the time the button was released will be displayed.
Dote)
@If the light source illumination is too bright or not bright enough, or if color temperature is out of
the measurement range, when the Measuring/OK button W is pressed, [0, Quer] (LI, Under] will
blink to indicate that measurements cannot be made. In this case, adjust the brightness or color
temperature. (See P30)
18
Advertisement
