Trane VUV Installation, Operation And Maintenance Manual page 51

Set the Time Format, Time, and Day
(Program to 24 hr or am/pm format.)
Figure 60. Time clock menu
1. Press the Menu button until the display screen is blank
(time not showing) and 24h or am/pm is blinking in the
upper left corner of the screen.
2. Use the + and/or - buttons to select the desired setting and
then press OK.
3. The hour display begins to blink—use the + and/or -
buttons to select the desired setting and then press OK.
4. The minute display begins to blink—use + / - to select the
desired setting and press OK.
5. The day display (on the left side of the display screen)
begins to blink—use + / - to select the desired setting and
press OK.
Set the Program
Note: The Time Clock should be used to program the unit for
the UNOCCUPIED mode—the periods of time when
the unit will not be in operation. The mode you are
programming is shown on the LED display:
: The Timer is in operation (ON). The unit is in
UNOCCUPIED mode.
: The Timer is not in operation (OFF). The unit is in
OCCUPIED mode.
Note: Odd number programs activate the timer ON function
(the unit is in UNOCCUPIED mode) and even number
programs activate the timer OFF function (the unit is in
OCCUPIED mode).
Set the Switching ON Time
Figure 61. Setting the switching ON time
1. Press OK until prog 01 is visible on the LED display.
Note: When prog 01 is visible, 01 should be blinking and
the ON symbol,
window. Press OK again.
2. The hour display begins to blink—use the + and/or -
buttons to select the desired setting and then press OK.
UV-SVX005G-EN
, should be displayed in the LED
3. The minute display begins to blink—use + / - to select the
desired setting and press OK.
4. The day display (on the left side of the display screen)
begins to blink—use + / - to select the desired setting and
press OK.
Note: After you set the switching ON time, the prog number
should increase by one (for example, from prog 01 to
prog 02). The number should be blinking and the OFF
symbol, , should be displayed in the LED window.
Set the switching OFF time.
Set the Switching OFF Time
1. The hour display begins to blink—use the + and/or -
buttons to select the desired setting and then press OK.
2. The minute display begins to blink—use + / - to select the
desired setting and press OK.
3. The day display (on the left side of the display screen)
begins to blink—use + / - to select the desired setting and
press OK.
Note: Repeat the steps for setting the switching ON/OFF
times for each additional programming needed. You
can set a maximum of 20 times: 10 switching ON
times, and 10 switching OFF times.
Preset Program Selections
When selecting daily programming, preset selections can be
used.
Figure 62. Preset program selection options
Possible week blocks and individual days
1
2
3
4
5
6
7
Installation - Controls
51