Agency Compliance; Wireless Display Sensor (Wds) - Trane VUV Installation, Operation And Maintenance Manual

Agency Compliance

The European Union (EU) Declaration of Conformity is
available from your local Trane® office.

Wireless Display Sensor (WDS)

Configuration Procedure
Note: Sensors shipped with the fan coil are pre-configured
for three speeds.
The configuration of the sensor determines which system
features can be accessed and changes can be made by the
tenant (for example, changes to cooling/heating mode,
setpoint, or fan speed. Verify system and associated unit
features before configuring the sensor.
The building owner or operator may choose to limit tenant
access to certain features. This can be done through
configuration. Or, if a sensor is configured to match all control
capabilities of the building automation system, the locking
feature can be used to restrict the tenant from making
changes.
To configure settings on the wireless display sensor (WDS),
follow this procedure in the order presented.
1. Press the configuration button for three seconds.
Figure 53. Configuration button
Table 14. Configuration options for wireless display sensors
Setting
Temperature
• Choose Fahrenheit or Celsius
• Choose the degree resolution (whole
degrees, half degrees, or tenths of
degrees).
Setpoint
UV-SVX005G-EN
Configuration
button
Configuration Options
. .
No Single
setpoint setpoint
The display will change to configuration mode. When the
sensor is in configuration mode, a wrench symbol appears on
the display and the menus are separated by lines, as shown in
Figure 54, p. 47.
Figure 54. Wrench is shown in configuration mode
2. Press the center button on the keypad to begin the
configuration process.
Figure 55. Center button of keypad
3. Configure the sensor options in the order shown in the
table.
• Press or to scroll to the next selection (as
illustrated).
• Press or
illustrated in Table 14, p.
4. Review the display to ensure that you have selected the
correct configuration.
5. To return the display to operating mode, press the
configuration button (see
Note: The sensor will revert to operating mode if no buttons
are pressed for 10 minutes.
.
.
Installation - Controls
Wrench
Center
button
to move to the next menu (as
47).
Step 1 on p. 47).
.
.
47