Trane VUV Installation, Operation And Maintenance Manual page 22

Installation - Mechanical
Note: Hex screws and lock washers are provided by the
factory. They are located in a baggy and are used
to attach the base to the unit ventilator. Pre-drilled
slots in the subbase flange will line up with the weld
nuts in the bottom of the unit.
3. The bottom of the subbase has weld nuts in four slots.
Place the leveling legs in those slots and level the unit.
NOTICE
Equipment Damage!
Failure to follow instruction below could result in
equipment failure. Do not run units for any length of
time without all panels and filters properly installed.
End Panels
When ordered as an option, end covers ship attached to the
vertical unit ventilator. The following section is for installing end
covers purchased as an add-on.
It is recommended end panels be installed on the unit ventilator
after all piping, wiring and accessory installation is completed.
To install the end panel:
1. Insert the four factory-provided metal studs into the four
pre-mounted nuts on the inside of the panel.
2. Align each stud with the four pre-drilled holes on the side
of the unit.
3. Secure the panel to the unit by fastening with the four
factory provided nuts.
4. Do not overtighten screws.
22 UV-SVX005G-EN