Table of Contents
Advertisement
16
C
3: I
HAPTER
NSTALLING THE
P
P
S
APER
ORT
OFTWARE
3. Click Find Scanner.
The setup program automatically finds the port where the PaperPort
scanner is connected and makes any changes to the port settings that
are necessary for the scanner to work properly. If the scanner and port
are properly connected, the scanner makes a short humming sound.
If the scanner is not connected correctly, a message tells you that the
scanner was "Not Found." Make sure that each cable is connected
correctly, and click Find Scanner again.
4. Click OK.
A message tells you to restart Windows to accept the new settings for
the port.
5. Click Restart.
That completes the installation of the PaperPort 3.6 Software. You now
need to calibrate the scanner.
C
P
ALIBRATING THE
Calibrating adjusts the scanner's internal scanning mechanism to produce
the best possible scan image. To calibrate, use the calibration page included
with the scanner. You can also use any plain white sheet of paper that is
9 inches (22.9 cm) wide and at least 6 inches (15.2 cm) long.
To calibrate the scanner:
Insert the 9-inch edge (the wider edge) of the calibration page into the
scanner. If you're using a regular white sheet of paper, insert it sideways,
not lengthwise, into the scanner.
The sheet should extend over the two page markers that you use as
guides when inserting items. The scanner grabs the sheet and
automatically feeds it through the scanner.
Calibration only takes a few seconds. Do not pull the paper out of the
scanner while calibration is in progress. When the calibration is
complete, the paper will be free so you can remove it.
That's it! Your scanner is now ready for you to scan.
P
S
APER
ORT MX
CANNER
Advertisement
Table of Contents
