Setting Up Your Scanner To Work With Paperport - Visioneer Patriot 470 User Manual

S
ETTING
S U Y
ETTING P OUR
P P
APER ORT
When you selected a scanning option from the Scanner drop-down list,
either TWAIN: Visioneer Patriot 470 (Strobe XP 470) or WIA:
Visioneer Patriot 470 (Strobe XP 470) (Windows XP or Windows
Vista only), the Scan button at the bottom of the panel should become
active. If it doesn't, you need to set up PaperPort to work with your
scanner.
If this Scan button is not active, you need to
set up PaperPort to work with your scanner.
Note: Setting up your scanner is a one-time-only process for each
option from the Scanner drop-down list. Therefore, you may have to
set up your scanner once each for TWAIN: Visioneer Patriot 470
(Strobe XP 470) and WIA: Patriot 470 (Strobe XP 470). The
setup process, described below, is the same for each option. You will
not have to set up the scanner again for an option unless you
uninstall the scanner and PaperPort software, then re-install them.
U Y S
P OUR CANNER TO
S W
CANNER TO ORK
W W P P
ORK ITH APER ORT
W
ITH
109