Table of Contents
Advertisement
34
A
A: T
PPENDIX
ROUBLESHOOTING
Connect the scanner to another computer where the PaperPort software
is already installed.
Install and use one scanner on the computer and then connect a
different scanner to the computer.
To recalibrate the PaperPort scanner:
1. Use the calibration page that you received with the scanner, or cut or
fold a blank, white piece of paper so that it is 9 inches (22.9 cm) wide
and at least 6 inches (15.2 cm) long.
2. Click the Settings button on the Command Bar. If you're using
Windows 95, click the Scanner Setup tab.
3. Click the Setup button to display the Scanner Setup dialog box.
4. Click the Calibration button. A message asks you to insert the paper
to begin calibrating the scanner.
5. Insert the 9-inch (22.9 cm) edge of the paper into the center of the
scanner's page feed slot. Or click Cancel to skip the calibration.
Advertisement
Table of Contents
