Setting Up Your Scanner To Work With Paperport - Visioneer STROBE XP 300 User Manual

106 V S
ISIONEER TROBE
XP 300 S U '
CANNER SER S
S U Y
ETTING P OUR
P P
APER ORT
When you selected a scanning option from the Scanner drop-down list,
such as TWAIN: Visioneer Strobe XP, the Scan button at the bottom
of the panel should become active after approximately 5 to 10 seconds.
If it doesn't, you need to set up your scanner to work with the selected
option.
If this Scan button is not active,
you need to setup your computer.
Note: Setting up your scanner is a one-time-only process for each
option from the Scanner selection list. Therefore, you may have to set
up your scanner once each for TWAIN: Visioneer Strobe XP and
WIA: Visioneer Strobe XP. The setup process, described below, is the
same for each option. You will not have to set up the scanner again for
an option unless you uninstall the scanner and PaperPort software,
then re-install them.
G
UIDE
S W
CANNER TO ORK WITH