Headlight Beam Leveler (Models With Led Headlights) - Subaru Crosstrek 2020 Manual

3-72
Instruments and controls/Headlight beam leveler (models with LED headlights)
You can turn the SRH function on or off by
pressing the SRH OFF switch.
1) SRH OFF indicator light
The SRH OFF indicator light on the
combination meter turns off when SRH is
turned on.
The SRH OFF indicator light on the
combination meter illuminates when SRH
is turned off.
If SRH is malfunctioning, the SRH OFF
indicator light on the combination meter
flashes when the ignition switch is in the
"ON" position. It indicates that SRH has
been deactivated. Contact a SUBARU
dealer for an inspection.
NOTE
. If you turn the ignition switch to the
"OFF" position with SRH turned off and
then start the engine again, SRH will
automatically turn on.
. When you turn the ignition switch to
the "ON" position, the SRH OFF indi-
cator light will illuminate and turn off
after several seconds.
. SRH only activates when the vehicle
is traveling forward at the speed of
approximately 5 mph (8 km/h) or more.
. SRH may not activate when the shift
lever (MT models) is selected in 1st
gear.
Headlight beam leveler
(models with LED headlights)
The LED headlights produce more light
than conventional halogen headlights.
When the vehicle is carrying a heavy load
and the headlight beams are angled
upwards, the driver of an oncoming vehicle
may experience glare.
To prevent this, the automatic headlight
beam leveler adjusts the headlights to the
optimum height automatically depending
on the load the vehicle is carrying.
CAUTION
For CVT models, in certain circum-
stances, the headlights may become
misaligned, and the headlight beam
leveler will not reset them to the
proper angle. This may occur after
transporting your vehicle on a flat-
bed truck, or if the vehicle is parked
and restarted on different angles. In
such cases, have the headlight
alignment checked by a SUBARU
dealer.