Table of Contents
Advertisement
Figure 138: Installing the heat sink (C)
▶ Fasten the four captive screws (see circles) following the sequence
described below using a T30 Torx screwdriver:
▶ Fasten the four captive screws one by one (in the sequence 4 to 1)
rotating them a half-turn each.
▶ Tighten the captive screw 4 and and then screw 3 rotating them two or
three turns each.
▶ Tighten the captive screw 2 and then screw 1 rotating them two or three
turns each.
▶ Repeat the step 2 until the screw 4 and screw 3 are completely fastened.
▶ Repeat the step 3 until the screw 2 and screw 1 are completely fastened.
GX2560 M7
Upgrade and Maintenance Manual
Processor (CPU)
189
Advertisement
Table of Contents
