Table of Contents
Advertisement
Note on network settings recovery
When replacing network controllers, network configuration settings in
the OS will be lost and replaced by default values. This applies to all
static IP address and LAN teaming configurations.
Ensure to note down your current network settings before replacing a
controller.
Preliminary steps
▶
"Locating the defective server" on page 37
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Extending the server out of the rack" on page
▶
"Removing the server from the rack" on page
▶
"Removing the cover 2" on page
▶
"Removing the air duct" on page
▶ Remove the desired riser module, see
page
62.
Removing the defective expansion card
▶ Remove the expansion card, see
page
157.
▶ If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see
Installing the new expansion card
▶ If applicable, install the slot bracket, see
page
140.
▶ Install the expansion card, see
GX2560 M7
Expansion cards and riser modules
38.
47.
58.
"Removing the riser module" on
"Removing the expansion card" on
"Removing slot brackets" on page
"Installing the expansion card" on page
Upgrade and Maintenance Manual
38.
39.
39.
41.
"Installing slot brackets" on
142.
152.
159
Advertisement
Table of Contents
