Note the lower left hand fastener
▼
also secures the oil filter cover
between the sprocket cover and
crankcase.
Install and tighten the fastener to
▼
89 lbf in (10 Nm).
2
B01301
1.
Sprocket cover
2.
Fasteners
Install the TSA shift force sensor
▼
upper ball socket to the gear shift
knuckle ball joint and secure with
the wire clip.
B01552
1.
Wire clip
2.
TSA shift force sensor
Start the engine and allow it to idle
▼
for a minimum of 30 seconds.
1
1
2
MAINTENANCE
Caution
Raising the engine speed above idle
before the oil reaches all parts of the
engine can cause engine damage or
seizure.
Only raise engine speed after running
the engine for 60 seconds to allow the
engine oil to circulate fully.
Caution
If the engine oil pressure is too low,
the low oil pressure warning light will
illuminate. If this light stays on when
the engine is running, stop the engine
immediately and investigate the cause.
Running the engine with low oil
pressure will cause engine damage.
Make sure that the low oil pressure
▼
warning light remains off and the oil
pressure message is not shown in
the instrument display screen.
Stop the engine and recheck the
▼
engine oil level. Adjust if necessary.
Disposal of Used Engine Oil and Oil
Filters
To protect the environment, do not
pour oil on the ground, down sewers or
drains, or into groundwater sources.
Do not place used oil filters in with
general waste. If in doubt, contact your
local authority.
115