Table of Contents
Advertisement
▼ Fit and tighten the fixings to 10 Nm.
2
B01301
1. Sprocket cover
2. Fixings
▼ Fit the TSA shift force sensor upper
ball socket to the gear change
knuckle ball joint and secure with the
wire clip.
B01552
1. Wire clip
2. TSA shift force sensor
▼ Start the engine and allow it to idle
for a minimum of 30 seconds.
1
1
2
MAINTENANCE
Caution
Raising the engine speed above idle
before the oil reaches all parts of the
engine can cause engine damage or
seizure.
Only raise engine speed after running
the engine for 60 seconds to allow the
engine oil to circulate fully.
Caution
If the engine oil pressure is too low,
the low oil pressure warning light will
illuminate. If this light stays on when
the engine is running, stop the engine
immediately and investigate the cause.
Running the engine with low oil
pressure will cause engine damage.
▼ Make sure that the low oil pressure
warning light remains off and the oil
pressure message is not shown in
the instrument display screen.
▼ Stop the engine and recheck the oil
level. Adjust if necessary.
Disposal of Used Engine Oil and Oil
Filters
To protect the environment, do not pour
oil on the ground, down sewers or
drains, or into watercourses.
Do not place used oil filters in with
general waste. If in doubt, contact your
local authority.
119
Advertisement
Table of Contents
