Table of Contents
Advertisement
MAINTENANCE
114
After the engine oil has completely
▼
drained out, install a new sealing
washer to the drain plug. Install and
tighten the drain plug to 18 lbf ft
(25 Nm).
Always fill the engine with clean
engine oil prior to installing the new
engine oil filter.
Installing the new engine oil filter
before filling the engine will create an
air lock in the oil gallery and engine oil
starvation.
Engine
oil
premature engine damage leading to
engine failure.
Fill the engine with a 10W/40 or
▼
10W/50
motorcycle engine oil which meets
specification API SH (or higher) and
JASO MA, such as Castrol Power
1 Racing 4T 10W-40 (fully synthetic)
engine oil, sold as Castrol Power RS
Racing 4T 10W-40 (fully synthetic) in
some countries.
A new engine oil filter must be
installed each time the engine oil is
replaced.
If the engine oil filter is not changed,
it will create an airlock and prevent
engine
oil
achieved and the engine oil pressure
warning light will remain on.
Caution
starvation
will
semi
or
fully
synthetic
Caution
pressure
from
Apply a thin smear of clean engine
▼
oil to the sealing ring of the new
engine oil filter.
Install the new engine oil filter and
▼
tighten to 89 lbf in (10 Nm) using
Triumph service tool T3880313.
Install the engine oil filter cover
▼
with the wire guide in the same
orientation
Tighten the fastener to 27 lbf in
(3 Nm).
Attach
▼
connector to the engine oil filter
cover.
Route the harnesses and hoses
cause
▼
through the wire guide as noted for
removal.
B01551
1.
Side stand switch connector
2.
Fastener
3.
Cover
4.
Wire guide
5.
Engine subharness
6.
Fuel tank drain hose
7.
Coolant expansion tank drain hose
Position
being
▼
the crankcase with the coolant
expansion tank hose, fuel tank
vent hoses and the oxygen sensor
harness positioned as noted for
removal.
noted
for
the
side
stand
3
7
6
the
sprocket
removal.
switch
5
4
2
1
cover
to
Advertisement
Chapters
Table of Contents
