Triumph Speed Triple 1200 RR 2022 Owner's Handbook Manual page 40

GENERAL INFORMATION
40
To change the selected riding mode:
Press the joystick down or up, or
▼
repeatedly press the MODE button
until the required riding mode is
highlighted in the center of the
riding mode selection tray.
A brief press of the joystick center
▼
will select the required riding mode,
and the riding mode icon in the right
hand side of the display will change.
The selected mode is activated
▼
once the following conditions for
switching modes have been met:
Motorcycle Stationary - Engine Off
The ignition is switched ON.
▼
The engine stop switch is in the
▼
RUN position.
Motorcycle Stationary - Engine Running
Neutral gear is selected or the
▼
clutch is pulled in.
Motorcycle in Motion
Within 30 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
Close the throttle.
▼
Make sure that the brakes are not
▼
engaged (allow the motorcycle to
coast).
Note
It is not possible to select RIDER modes
while the motorcycle is in motion, if the
TC settings are set to OFF.
In this case, the motorcycle must be
brought to a stop before the riding mode
change can take place.
If a riding mode
completed, the riding mode icon will
alternate between the previous riding
mode and the newly selected riding
mode until the change is complete or it
is canceled.
The riding mode selection is now
complete and normal riding can be
resumed.
change is not