Engine Oil And Filter Change - Triumph Speed Triple 1200 RR 2022 Owner's Handbook Manual

MAINTENANCE
112
To inspect the engine oil level:
Start the engine and run at idle for
▼
approximately five minutes.
Stop the engine, then wait for at
▼
least five minutes to allow the oil to
settle.
Note the oil level visible in the sight
▼
glass.
When correct, oil should be visible at
▼
a point between the upper level and
the lower level on the sight glass.
If it is necessary to top off the
▼
oil level, remove the oil filler plug
and using a suitable funnel, add
oil, a little at a time, until the level
registered in the sight glass is
correct.
Once the correct level is reached,
▼
install and tighten the oil filler plug.

Engine Oil and Filter Change

Prolonged or repeated contact with
engine oil can lead to skin dryness,
irritation and dermatitis.
Used engine oil contains harmful
contamination that can lead to skin
cancer.
Always wear
clothing and avoid skin contact with
used engine oil.
Warning
suitable protective
Warning
The engine oil may be hot.
Avoid contact with the hot engine
oil by wearing suitable protective
clothing, gloves and eye protection.
Contact with hot engine oil may cause
the skin to be scalded or burned.
Warning
If the engine has recently been
running, the exhaust components may
be hot to the touch.
Contact with the hot components may
cause damage to exposed skin.
To avoid skin damage, always allow the
hot parts to cool before touching the
exhaust system.
The engine oil and engine oil filter
must be replaced in accordance with
scheduled maintenance requirements.
Warm up the engine thoroughly,
▼
and then stop the engine and
secure the motorcycle in an upright
position on level ground.