Triumph Speed Triple 1200 RR 2022 Owner's Handbook Manual page 54

GENERAL INFORMATION
54
Push the
▼
decrease/increase
suspension parameter in increments
of 1, between the limits of -5 and 5.
Once the suspension parameter
▼
has been set accordingly, press the
joystick center to confirm.
Repeat the procedure to set any
▼
other suspension parameters.
Push the joystick left to return to
▼
the previous menu.
Settings - Traction Control
The Traction Control (TC) system can
be temporarily disabled. The Traction
Control system cannot be permanently
disabled, it will be automatically enabled
when the ignition is turned off and then
on again.
To enable/disable the traction control:
From the Settings menu, push the
▼
joystick down/up to select the
Traction Control option.
Push the joystick right to move the
▼
slider dot to the right to enable
traction control.
Push the joystick left to move
▼
the slider dot to the left to disable
traction control.
For more
control, see page 70.
joystick left/right
the relevant
information on
Settings - Triumph Shift Assist
to
Triumph Shift Assist (TSA) triggers a
momentary engine torque change to
allow gears to engage, without closure
of the throttle or operation of the
clutch. This feature works for both up-
shifts and down-shifts of gear.
The clutch must be used for stopping
and pulling away.
Triumph Shift Assist will not operate if
the clutch is applied or if an up-shift is
attempted by mistake when in 6th gear.
It is necessary to use a positive pedal
force to make sure there is a smooth
gear shift.
To enable/disable Triumph Shift Assist:
From the Settings menu, push the
▼
joystick down/up to select the
Triumph Shift Assist option.
Push the joystick right to move the
▼
slider dot to the right to enable
Triumph Shift Assist.
Push the joystick left to move
▼
the slider dot to the left to disable
Triumph Shift Assist.
For more information on Triumph Shift
Assist, see page 91.
traction