Table of Contents
Advertisement
3. The staners armature snould be
checked with an ohm meter for nsula-
tion breakeown {shorting tn eacr other
or 10 ground) and for continuity.
Re-
t
ference figure is given below.
Col! resistance
Armature coil: 0.0144 (20°C)
Continuity enack
5. Check brush length Replace brush if at.
or near, limits
8.5 mm (0.33 ind
neu ation eneck
6 Check brush spring pressure. Compare
t with a new spring, Replace the old
spring ifit is we
4. Check the front and rear cover bushes
for damage, if damaged, tne starter
assembly must be replaced,
613
Advertisement
Table of Contents
