Yamaha SR250G Service Manual page 15

Table of Contents

Advertisement

Front
Spoke Adjustment anc Tension
Adjust rear wheel sooxa tension por front
wheel instructicns,
Hear Axle
Check axle nur.
Rear axle nut torque
10.7 m-kg (77.5
ft-lb)
Tire Pressure
See page 5-3 "Installation"
Drive Chain Tension Cheok
Note:
Before
jecking and/or adjusting, rotate the
wiwel though several revolutions and
check tension at sevars|
pomts to find the
tightest point, Check end/o-
adjust the chin
tensor with the rear wheel in this "tightest"
pos ior
Inspect the drive chain with the center
stand put. Check the tension at the pesition
show in the illustration. The normal vertical
deflection is approximately 25 ~ 35 mm
110 ~ 1.4 in) If the deflection exceeds 35
mn (14 in) adjust *he chain tension
Drive Chain Tension Adjustinent
1. Locsen the rear brake adjuster
Re 2tabo odiustr
2. Remove the cotter pin of the rear whee!
axle nut with pliers,
3. Locson the rear whee! axle nut.
4. Ture the chain puller both left and right
unt! exle i s situated in same puller slot
position on each
side.

Advertisement

Table of Contents
loading

Table of Contents