Table of Contents
Advertisement
Clutch
1. First install the primary drive gear,
2. Install the clutch housing, thrust plete,
puso rod 2, nell and clutch
boss in that
order.
3. Install clutch holding tool on clutch boss
and tighten loc nut.
teh lock nut torque
7.0 m ky (50.6 ft-lb)
Tightening torque:
6.0 m-ka (43.4 ft-lb)
a
Bend the lock washer.
6. Install the starter clutch assembly and
the primary drive gear then install the
starter motor with the c!
4 Install the pus) rod 2 and ball into main.
axle
5 Install clutch plate and friction pte.
6.
Install clutcn pressure plate.
7 Continue instellaton of clutch end fric
vor plates.
NOTE:
=
Align the arrow mark on the clutch boss end
Push Lever Assembly
prossure plate mark,
Sets
rque: 12 kg (8.7 fel
8.
Tighten the primary crive lock nut by
first pacing @ feldee rag between the
teeth of the primary gears to lock ther
as chown in the prota
3.23
Advertisement
Table of Contents
