Table of Contents
Advertisement
4. Intal| the flywheel magneto base to left
side of crankcase.
NOTE
1,
It the "O-ring"
\s defecth
deteriorated, replace it
2. Apply a thin coat of grease over the "O
ning"
and then put te
magneto
plete
in the crank
case
Pay attention :o ths parallelism be
tween the piste and the crankcase st
face
Install the
l e s :
swollen or
'wire grommet oroperly.
5. Clamp the lead wire to the crankcase
NOTE:
Be sure the les wir> will not becom: loosen.
6. Install the fywheel
NOTE
When
installing
flywheel,
make
sure
woodiuf' key is properly seated in keyway of
cranksh=ft, Carefully install flywhes! taking
to align wit)| woodruff key
7 Install plate washer, spring washes and
Jock 'at
Tightening torque, 8,0 1-ky (57.8 fib)
|
8. Tighton tho cam sprocket bolt
mn sprocket holt tightening torque:
5.5 m kg (38.8 *t-1b)
9. Install the chain cansioner assemoly
Adjust the tensiviw).
(Refer to the
Chapter 2. "Cam chain adjustment")
10. Insteil the adjuster cap ene tighten the
cap.
| Tightening torque' 0.6 m-kg (3.6 ft-lv)
Advertisement
Table of Contents
