Table of Contents
Advertisement
©. While still supporting the uncer bracket
carefully lift off the upger besring cover
Lift off the top bearing race and remove
all of the ball bearings from the upper
bearing assembly,
—
| Ball quantity/size: 1 pes.
12. Remove the bracket while being very
caroful not to lose any bell bearings
from the lower essembly
Ball quantity/size. 19 pes., 1/4
Hemove the bearing races from head
sige using a drift punch and hammer
as shown. Work the rece out
gradually
by tapping lightly sround its complete
diamezar.
14. Remove the bearing race from the
lower bracket by tapping around its
diameter
with 2 dnft punch and ham-
mer.
NOTE, —
Remove the dust se*
Inspection
1. Examine all the balls for pits or partial
flatness. If any o
defective,
the entre set (including both races)
should be replaced. If either race is pit
Tee, shows rust spots, oF is damaged in
any way, replace both races and all balls.
2 Examine dust sea)
under lowest race
and replace f damaged
w is four
Installation
1. If pressed-in races heve 5
top in new races.
2.
Grease the ower bail race
of the bottom
assembly and arrange the balls around
it Then apply more
grease.
3. Grease the lower dali race of the upper
assembly and arrange the bal/s around
it Then apply more grease and set the
top race inte place.
removed,
Advertisement
Table of Contents
