Table of Contents
Advertisement
11 Instruction for Installing the Casings
Before proceeding with the installation of the
display should immediately check if the
packaging where the display is located is in
perfect condition, any damage should be
reported and reported before proceeding with its
installation.
To proceed with the assembly of the display the
installer will require a 10mm spanner.
NOTE : Before installing the display the pellet
stove must be electrically disconnected
After unpacking the device, remove the
a)
upper cover of the device by applying a slight
upward force, the cover is spring-loaded and no
screws need to be removed.
See Fig xx
Figure 11Removal of stove top
The next step is to remove the display.
Caution: When placing the display, handle it
with care as there is a cable from the stove
board connected to it. Disconnecting this cable
does not allow the unit to operate correctly
Remove the packaging inside the hopper
containing the display.
Figure 12Fitting of display.-1
Place the display on the back of the machine
as shown in Figure xx. To do this, slightly loosen
the screws on the back. When tightening the
display it may be necessary to make a height
adjustment. Re-attaching the stovetop to the
equipment.
Figure 13Fitting of display.-2
Figure 14 Fitting of display.-3
.
21
Advertisement
Table of Contents
