Turn On The Switch; Connect Network Interface Cables; Use The Ethernet Interface With An Rj45 Connection - Extreme Networks ISW Series Installation Manual

Turn on the Switch

To connect the ground connection:
1. Locate the grounding point at the rear of the chassis, which is marked by the
international symbol for earth ground.
2. Strip the insulation to expose 1/2 inch (12 mm) of bare wire at one end of the
grounding wire.
3. Wrap the bare grounding wire around the provided M3 or M4 earth ground screw.
4. Use a straight-tip torque screwdriver to tighten the retaining screw to 20 in‑lb (2.25 N
m).
5. Connect the other end of the grounding wire to a known reliable earth ground point
at your site.
Turn on the Switch
Use the following instructions to turn on the device.
1. Verify that the AC circuit is de-energized.
2. Verify that the AC power input cables are properly connected to both the AC circuit
and the AC terminal block on power supply.
3. Verify that the DC power input cables are properly connected from the power supply
to the DC terminal block on the top or the rear of the switch.
4. Verify that the ground wire is connected to the grounding lug on the rear of the
device.The grounding lug is identified by the international symbol for earth ground:
5. Energize the circuit.
6. When power is connected, verify that the PSU LED is green.
If the PSU LEDs do not turn green, refer to the
your device for troubleshooting information.

Connect Network Interface Cables

Use the appropriate type of cable to connect the ports of your switch to another switch
or router.
Cable Type
CAT5E
CAT6
CAT6A

Use the Ethernet Interface with an RJ45 Connection

ISW-Series provides two types of electrical (RJ45) and optical (mini-GBIC) interfaces.
•
To connect to a PC, use a straight-through or a cross-over Ethernet cable.
44 ISW Series Managed Industrial Ethernet Switch Hardware Installation Guide
Monitor the Switch
Maximum Distance
55 meters
55 meters
100 meters
Install Your Switch
on page 51 topic for