Unpacking; Uncrating - 3M -Matic 200a Instructions And Parts List

6-UNPACKING

6.1 Uncrating

The envelope attached to the shipping box contains
the uncrating instructions of the machine (Figure 6-1).
Cut straps. Cut out staple positions along the bottom
of the shipping box (or remove staples with an
appropriate tool - Figure 6-2)
After cutting out or removing the staples, lift the
shipping box in order to clear the machine
(two persons required).
Transport the machine with a fork-lift truck to the op-
erating position. Lift the pallet at the point indicated in
Figure 6-3 (weight of machine - See Specifications /
Section 4).
200a-NA
Figure 6-1
Figure 6-2
Figure 6-3
Removal of Pallet
Using a 10mm combination wrench, remove the
fasteners that secure the case sealer legs to pallet at
each leg (as shown in Figure 6-4).
Figure 6-4
A package is located under the machine body.
Retrieve the instruction manual for additional proce-
dures of the set up. The package also contains parts
removed for shipping, spare parts and tools
(Figure 6-5).
Figure 6-5
6.2 Disposal of Packaging Materials
The 200a package is composed of:
- Wooden pallet
- Cardboard shipping box
- Wooden supports
- Metal fi xing brackets
- PU foam protection
- PP plastic straps
- Dehydrating salts in bag
- Special bag of laminated polyester/aluminium/
Polyethylene (sea freight package only)
- Polyethylene protective material
For the disposal of the above materials, please follow
the environmental directives or the law in your country.
16
2011 June