Enabling/Disabling Dc5V Output; Displaying Or Hiding The Grayscale Warning; Enabling/Disabling Sharpness Recovery - Eizo Radiforce GX550 Installation Manual

3-10. Enabling/Disabling DC5V Output

The DC5V output can be enabled/disabled. Turn off this setting normally.
Procedure
1. Touch to turn off the power to the monitor.
2. While holding down the switch at the far left ( ), touch
monitor power.
3. Select "DC5V Output" from "Administrator Settings", and choose
4. Select "On" or "Off" with
5. Select "Apply" with
6. Select .

3-11. Displaying or Hiding the Grayscale Warning

When the DisplayPort signal is input in a recommended resolution, the grayscale display error message
may be displayed if the monitor detects a 6-bit (64-gradation) signal. When the error message is
displayed, turn off the main power of the monitor, and then turn it on again.
Attention
• Turn "On" this setting normally (the factory default is "On").
• Turn "Off" this setting only when you use the monitor in 6-bit (64-gradation).
Procedure
1. Touch to turn off the power to the monitor.
2. While holding down the switch at the far left ( ), touch
monitor power.
3. Select "Grayscale Warning" from "Administrator Settings", and choose
4. Select "On" or "Off" with
5. Select "Apply" with
6. Select .

3-12. Enabling/Disabling Sharpness Recovery

Sharpening image can be enabled or disabled. Enabling it enhances the sharpness of images.
Procedure
1. Touch to turn off the power to the monitor.
2. While holding down the switch at the far left ( ), touch
monitor power.
3. Select "Sharpness Recovery" from "Administrator Settings", and choose
4. Select "On" or "Off" with
5. Select "Apply" with
6. Select .
Attention
• After changing the setting, perform a visual checkup based on medical standards/guidelines.
or , and choose
or .
or , and choose
or .
or , and choose
or .
for at least two seconds to turn on the
.
.
for at least two seconds to turn on the
.
for at least two seconds to turn on the
.
Chapter 3 Setting the Monitor
.
.
13