Rotating The Image; Selecting The Input Signal For Ddc Communication - Eizo Radiforce GX550 Installation Manual

3-8. Rotating the Image

The display direction of the image can be changed according to your environment.
Attention
• Refer to the User's Manual of the graphics board.
• The setting is available even when the PC is not started up.
Procedure
1. Touch to turn off the monitor power.
2. While holding down the switch at the far left ( ), touch
monitor power.
3. Select "Image Rotation" from "Administrator Settings", and choose
4. Select "Portrait" or "Landscape" with
5. Select "Apply" with
6. Select after completing the setting.
Landscape
Selected for horizontal installation.
Portrait
Selected for vertical installation.

3-9. Selecting the Input Signal for DDC Communication

Specify the input signal with which DDC communication is used. Use "Auto" normally. By using DDC
communication, you can use RadiCS LE without connecting a USB cable. (This is different from the
DDC/CI communication.)
Procedure
1. Touch to turn off the monitor power.
2. While holding down the switch at the far left ( ), touch
monitor power.
3. Select "DDC" from "Administrator Settings", and choose
4. Select "Off", "DVI" "DisplayPort" or "Auto" with
5. Select "Apply" with
6. Select .
Note
• When "Auto" has been selected, DDC communication can be used for any input signal.
12
Chapter 3 Setting the Monitor
or , and choose
or .
Monitor orientation
or .
for at least two seconds to turn on the
.
.
for at least two seconds to turn on the
.
or , and choose .
Display example
A
A