Gateway E-1000 Series Maintaining And Troubleshooting page 71

60 Maintaining and Troubleshooting Your E-1000 Series System
Error Message
Memory errors were
detected while the system
powered up.
Memory size error.
Non-system disk or disk
error.
Not enough memory.
Print queue is full.
Printer is out of paper.
Required parameter
missing.
Syntax error.
Time and date not set.
Write protect error.
Solutions
See "Memory errors were detected during
system start up." on page 47.
Enter BIOS Setup and save the memory
configuration.
•
Eject the diskette and press
•
If the diskette is bootable, check it for
errors.
Close all programs that are not currently in
use.
•
Wait until the current print job has
completed before sending another print
job.
•
If you receive this error often, you need to
add memory to the printer.
•
Add paper to the printer.
•
Make certain the printer is online.
•
Make certain you entered the right
command.
•
If you are trying to exit MS-DOS to return
to Windows, type exit and press
•
Make certain you entered the right
command.
•
If you are trying to exit MS-DOS to return
to Windows, type exit and press
Enter BIOS Setup to set the system's date
and time.
Move the write-protection tab over the hole
on the back of the diskette.
E
.
NTER
E
.
NTER
E
.
NTER