Gateway E-1000 Series Maintaining And Troubleshooting page 25

14 Maintaining and Troubleshooting Your E-1000 Series System
Set the fansink flat on the processor. The four corner posts should
7.
wrap around the four corners of the processor base so that the fansink
cannot move from side to side.
Press the metal retaining clips down until they hook into place. Make
8.
sure that the fansink is level and that all four corners extend below the
black plastic edge of the processor base. It is very important that the
fansink makes direct contact with the processor or else it will not cool
correctly, resulting in processor failure.
Connect the fansink power cable to P8 (fan connector) on the
9.
system board.
Set the configuration switches to match your processor speed. (See
10.
"Configuration Switches" on page 15.)
11. Close the system as described in chapter 1.
Reconnect the power cord and turn on the system.
12.