Gateway E-1000 Series Maintaining And Troubleshooting page 37

26 Maintaining and Troubleshooting Your E-1000 Series System
Tilt the hard drive up, slide the fingers on the bracket opposite the pull
5.
ring, pull away from the retainers on the chassis, and lift the drive out
of the case.
6. Remove two screws on each side of the the mounting brackets, and
remove the drive.
Attach the mounting brackets to the new drive, using the screws you
7.
removed in step 6.
Replace the drive into the chassis, making sure the spring latch clicks
8.
fully into position , and then attach the data and power cables.