Gateway E-1000 Series Maintaining And Troubleshooting page 32

Move the unit back towards the rear of the chassis until the locking
6.
tabs and support tabs on either side clear the chassis slots.
Metal pins
Fastening tab
Support tabs
7. Remove the screw from the fastening tab, and lift the drive out of the
bracket.
Place the new drive in the mounting bracket, aligning the drive screw
8.
holes with the metal pins on the inside and with the fastening tab on
the outside.
9. Replace the screw you removed from the fastening tab.
Position the mounting bracket in the system chassis.
10.
Secure the drive bay to the chassis with the screw removed in step 4.
11.
Plug in the power and data cables.
12.
Replace the bezel and chassis cover, plug in the power and other
13.
connectors, and turn on the system.
Locking tabs
Diskette drive mounting bracket
Components 21