24
Maintaining and Troubleshooting Your E-1000 Series System
Replace the mounting bracket in the chassis so that four lower tabs are
8.
on the outside of the chassis and the remaining tabs are on the inside.
Secure with the two screws you removed in step 5.
Plug the power and data cables into the back of the drive (see drive
9.
documentation for proper jumper settings and connector orientation).
If installing a CD-ROM drive, connect the audio cable to the CD
audio-in connector on the system board (callout "S" in the system
board diagram on page page 8).
Replace the bezel and the chassis cover, plug in power cords and attach
10.
peripherals, and turn on the system.
Run configuration software if required.
11.
Mounting bracket tabs shown in
white fit outside the chassis
Mounting bracket tabs shown in
gray fit inside the chassis