Table of Contents
Advertisement
WARNING DISPLAY
The WARNING display uses numerical codes to indicate various malfunctions and warnings on the counter display. Worded warning
messages are provided on-screen. In some cases, power must be turned off before the machine can be recovered. When the AUTO
OFF indicator lights, power must be turned on and off again before the machine can be recovered.
AUTO
OFF
Indicator
WARNING
(On-Screen Display)
WARNING 01
LAMP FAILURE
WARNING 02
CONDENSATION
ON DRUM
WARNING 08
SUP TENSION FAILURE
WARNING 32
FAILURE LOADING
°
WARNING 33
FAILURE UNLOADING
WARNING 41
CASSETTE EJECT FAILURE
Symptom/Operation
Tape-end sensor LED burns out. The cassette will be ejected.
Ail controls become inoperative.
Moisture condensation on drum and in transport.
The cassette is ejected. After ejection, the drum starts rotating and
cassettes cannot be loaded until condensation has been
eliminated. Do not turn the power off until the AUTO OFF indicator
goes out.
Slack tape on the supply reel.
All controls become inoperative.
Tape cannot load correctsy.
Tape unloads and the cassette is ejected. The display turns off
when a cassette is inserted again. Normal operation is restored.
Tape cannot unload.
All controls become inoperative.
Cassette carriage does not lift during tape ejection (even after 3
seconds have passed).
All controls become inoperative.
WARNING 56
TAPE DEFECTIVE
Tape beginning and end sensors turn ON during loading because
the tape is broken.
The cassette is ejected. If the cassette fails to load properly, it may
get stuck in the cassette slot. In this case, remove it by hand.The
display turns off when an undamaged cassette is inserted. Normal
operation is restored.
57
WARNING 57
Leader
Tape
Detection
END LEADER DETECTION
an ee
58
WARNING 58
BEGIN LEADER
DETECTION
35
Tape-end sensor turns ON during loading.
Rewind mode is engaged. If the leader tape is detected within 3
seconds, the cassette is ejected. The display turns off when a
cassette is inserted again. Normal operation is restored.
Tape-beginning sensor turns ON during loading.
FF mode is engaged. If the leader tape is detected within 3
seconds, the cassette is ejected. The display turns off when a
cassette is inserted again. Normal operation is restored.
Advertisement
Table of Contents
