JVC BR-S622E Instructions Manual page 28

Internal Regenerate Mode
This technique lets you record time code data on a new
recording in sync with the playback time code data on the
preceding recording. In automatic editing, jam-sync is also
available.
1. Set the INT/EXT switch to INT.
2. Set the PRESET/REGEN switch to REGEN.
External Regenerate Mode
This technique lets you record time code data regenerated in
sync with externally input time codes.
1. Connect an external LTC time code generator or the TIME
CODE OUT connector of another VCR to the TIME CODE IN
connector.
. Set the COUNTER switch to TC.
. Set the INT/EXT switch to EXT.
. Set the PRESET/REGEN switch to REGEN.
. Set the VITC REC switch as required.
6. Press the REC button in the Stop mode.
@ The REC indicator lights and the counter shows time code
running in sync with the external TC generator.
aor WP
NOTES:
@ When using an external VITC time code generator, menu item
#409 must be re-set to "01 — VITC" (cF p.31) and the VIDEO
IN connector must be used instead of the TIME CODE IN
connector.
@ The EE picture does not include the VITC signal.
When tapes with time code are played back, the rear panel
TIME CODE OUT connector outputs the playback time code
signal in its original form. The counter shows time code being
read by the internal TC reader (with COUNTER switch set to
TC).
if you need regenerated time code from the TIME CODE OUT
connector, re-set menu item #405 to "01 — TCG" («= p.31), and
set the front panel INT/EXT switch to INT and the
PRESET/REGEN switch to REGEN. To dub time code, or to
supply the playback time code signal to another VCR, use this
mode for more assured time code recording.
"4
8
Oi
INT/EXT switch
PRESET/REGEN switch
INT/EXT switch
PRESET/REGEN switch
VITC REC switch
COUNTER select switch
NOTES:
@ All time code data is cleared when power is switched off.
e For more options, refer to TIME CODE menu settings.
(c¥ p.31)